Product Manuals
Model RD Manual
|
Model TE Manual
|
Busy Dumper Manual
|
![]()
|
![]()
|
![]()
|
MAINTENANCE
GENERAL INSTALLATION INSTRUCTIONS
INSTRUCTIONS FOR PLOW MOUNT INSTALLATION
Bolt to the vehicle the snowplow attachment mount parts, do not tighten any fasteners beyond finger tight until all parts are installed. Then tighten all fasteners securely.
INSTRUCTIONS FOR ELECTRICAL INSTALLATION
Bolt to the vehicle the snowplow attachment mount parts, do not tighten any fasteners beyond finger tight until all parts are installed. Then tighten all fasteners securely.
INSTRUCTIONS FOR ELECTRICAL INSTALLATION
- Run light harness through firewall. Blue wire is for blinker, yellow is for parking. Blinker/parking bulb maybe separate or same bulb. Mount headlight switch in dash or accessory port. Red wire for high beam and black wire for low beam. Connect wires on same side of switch. Leave middle of switch open for black power wire from control harness.
- Bolt solenoid close to the battery, ground to body or alternator. Red power wire from solenoid to grill. Red power cable from solenoid to + positive on battery. Black ground cable to – negative on the battery. (Run + or – extension cables if necessary.)
- Run control harness through firewall. Brown wire to small bolt on solenoid. Black harness wire to middle of headlight switch. Splice fusible link into black harness wire, then connect fusible link to + positive on battery or key start fuse in fuse box.